Method of using clay stripping agent

Mud stripping agent is a chemical agent used to remove mud, mud, or dirt adhering to the surface. The following are the general methods for using clay stripping agents:

Preparation: Wear appropriate personal protective equipment, such as gloves and glasses. Ensure good ventilation in the work area.

Apply stripping agent: Apply the adhesive stripping agent to the surface that needs to be treated. It can be applied by brush, spray bottle or direct pouring. Determine the appropriate dosage and application time according to the instructions on the product manual.

Waiting time: Allow the stripping agent to fully penetrate and act on the sticky surface. According to the specific product requirements, wait for a period of time for the stripping agent to soften and separate the sticky mud.

Remove adhesive: Use a scraper, brush, or water rinse to remove the adhesive that has been softened by the stripping agent from the surface. Select appropriate methods for cleaning based on the properties of the clay and the requirements of the surface material.

Flushing the surface: Use clean water or appropriate cleaning agent to thoroughly rinse the surface and remove any remaining peeling agent and adhesive. Ensure that the surface is clean and free of dirt.

Cleaning and treatment: After cleaning the surface, perform necessary cleaning and treatment as needed to ensure that the surface is fully restored and meets the requirements.

When using adhesive stripping agents, please be sure to follow the instructions on the product manual and follow safety operating procedures to ensure your own safety and environmental protection. If there are special circumstances or difficulties, it is recommended to consult professionals or manufacturers for advice.